Search the forum,

Discuss Ideal logic + Heat 18 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
18
Afternoon all I was just wandering if the Ideal logic + heat 18 has a build in frost stat.
 
No they don't best to fit an external one, only problem is you need to be gas safe
 
No its not insulated. The boiler is in the garage. The garage is a new build. So not likely to get cold in there. But iv heard it's always best to have a frost stat if the boiler is outside the house.
 
No its not insulated. The boiler is in the garage. The garage is a new build. So not likely to get cold in there. But iv heard it's always best to have a frost stat if the boiler is outside the house.
Might invalidate the warranty on the boiler if you do not have one.
 
Ok great stuff. Just out of interest is the boiler in danger of not working if the garage gets a little chilly in the winter. Not Frezzing just cold.
 
How do you know it wont get to freezing temps?
Obviously you are wasting heat through non insulated pipes
 
As above, but I would get someone in to quote you before you decide it is a definite NO.
 
Only say it won't be Frezzing in there as it's a well insulated garage. Sorry the pipes going into the boiler are Insulated but the gas pipe is not. All this is in the garage. Hope that makes sense.
 
Sorry not read all above , you dont just insulate pipes to prevent freezing its also to prevent heat loss .
 
Ok thanks for advice. Only asked original question. As someone on the Web said it had a built in frost stat. And as they could not see an electrical connection for the cable.
 
Status
Not open for further replies.

Reply to Ideal logic + Heat 18 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Got fd code on Ideal Logic Heat 15. Had two plumbers out and no joy. It’s had a new water flow sensor, flush with sentinel x800 and refurbished grundfos water pump. Boiler tries to light and water pump power light comes on but goes off immediately and boiler flashes fd again. It’s heat only so I...
Replies
16
Views
608
Has anyone else come across this situation? I keep detecting products of combustion inside the casing of Ideal Logic boilers. I've replaced every seal I can find, namely flue seals, turret seals, sump connection seals, burner seal, electrode seal, flame detection seal, etc, and yet still I pick...
Replies
6
Views
310
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
179
Ideal logic heat 18. Uncoded intermittent fault near end of days use only. Burner reignites every 15 seconds on and off, but no fault code showing. Boiler isolated and restarted okay but same uncoded fault repeated at end of next day.
Replies
0
Views
703
Does anyone know of a weather compensation unit that can be fitted to a cylinder? I have an Ideal Logic Max H24 which heats a thermal store. The boiler can take an Ideal weather compensation unit to raise the target flow temperature as the outside temperature drops, but the store temperature...
Replies
0
Views
385
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock