Search the forum,

Hep 2o

Post new thread

Discuss Hep 2o in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gasmanrob

Plumbers Arms member
Plumber
Gas Engineer
Messages
3,238
100x 15mm 90
40x 15mm tee
350x smart sleeve inserts

open to sensible offers



image.jpg
 
Nah they are all overs. Been buried at the back of the shed. I'm boot fairing tomorrow and managed to make enough room to reach them
 
Just be careful that your employer doesnt jump to false conclusions.
 
I've had a pm from someone on the forum so for the second they have first refusal as they were in first.
 
gasmanrob said:
I've had a pm from someone on the forum so for the second they have first refusal as they were in first.
Click to expand...

Hi,

I'm only in Maidstone so if they decide not to have them I would be interested and could collect, just let me know what your after for them if they are still for sale.

Thank you
 
Status
Not open for further replies.

Reply to Hep 2o in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
200
ShaunCorbs
ShaunCorbs
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
dreikher
dreikher
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
115
Lou
Lou
B
Posting a thread as until now I've only read the forum
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
0
Views
33
Bob Kerr
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock