Discuss Having a moment... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Riley

Super Moderator
S. Mod
Plumber
Gas Engineer
Subscribed
Messages
10,854
Full of cold and head is not functioning.

Whats the minimum fall on 2in waste pipe??
 
Depends on length but bubble on edge of line on level
 
Cheers Shaun, i'm glad I'm not the only one that uses that standard measurement method
 
Things only go up hill in the gay club. (so i have been told)
 
Few interesting videos on utube with water going uphill !
 
Status
Not open for further replies.

Reply to Having a moment... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down...
Replies
2
Views
179
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON...
Replies
6
Views
300
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
406
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
332
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
235
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock