Discuss Glow worm cx 24 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
F

fatoftheland

We have just installed the above boiler in a customers house. They specified this boiler as they had a Glowworm already.

It should have been a 3 hour job, combi off, combi on.

The boiler comes with a jig to help pre plumbing. When the jig part is used the pipes are over 12mm away from the boiler.
The flue inner cover hits the boiler top. The bottom fixing screws are impossible to get at. The rear flue is a joke. The controls are rubbish. There is an electronic pressure guage so if you have an electrical fault you have no idea if there is water in the boiler.
It took 2 days to fit this boiler.
The aav is too low and nearly impossible to reach
Never Again.
Vaillant now own Glowworm so I expected a great product.
 
Status
Not open for further replies.

Reply to Glow worm cx 24 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I am just after some advice on my Glow worm Combi Compact 80e. Background- The boiler started to drop pressure a few weeks ago and required...
Replies
4
Views
9K
DannyS
D
R
  • Locked
Morning all, i'm new to the site looks very informative - i have a few questions that i'd like to pose if i may. over the...
Replies
6
Views
3K
Dotty
D
A
  • Locked
Hello all i wounder if someone could help me. About 6 months ago i had a new Glow worm combi boiler fitted, and ever since the boiler pressure...
Replies
5
Views
19K
lame plumber
L
S
  • Locked
About me: non-professional, average DIY guy. new to this forum. My boiler: Glowworm Flexicom24cx combi Long story short, yesterday I set...
Replies
7
Views
1K
U
  • Locked
Hi, I'm looking for some advice as I'm worried my builder / plumber are going to leave me with inadequate plumbing / hot water at the end of a...
Replies
3
Views
1K
Dotty
D
Back
Top