Search the forum,

Fitting peglers PB300T

Post new thread

Discuss Fitting peglers PB300T in the USA area at PlumbersForums.net

J

Johncg

Messages
2
I have a pegler PB300T isolation ball valve which has no flow arrow. I notice that the copper tube goes in further on one side than the other. Which way round should this be fitted.

Thanks

John G
 

Attachments

  • Screenshot_20210304-210346.png
    Screenshot_20210304-210346.png
    517.6 KB · Views: 11
In the pic the right hand to the outlet side eg left to the supply
 

Reply to Fitting peglers PB300T in the USA area at PlumbersForums.net

Similar plumbing topics

D
UK Pipes for thermostat shower fitted at different heights
Pipes for thermostat shower have been fitted at different heights. Any way of rectifying without ripping all tiles. So for clarity 15mm pipes sunk into wall behind bath. Walls have fresh tiles. Have realised as about to fit shower these pipes one is set higher than the other. If you fit a...
Replies
2
Views
235
fowlerboi
F
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
301
exedon2
exedon2
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
225
ShaunCorbs
ShaunCorbs
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
259
mutley racers
M
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
236
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Contractor Talk
Electricians' Talk
DIY Advice
DIY Forum
UK Tiling Forums
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock