Comments and feedback constructive or otherwise welcome.

[solutions]

Be gentle......

Isn't that a runner up for the Turner prize.

 

[REDSAW]

sorry solutions, that one made me chuckle....
why pull a bend on the blow off then solder a joint anyway?
could have just used elbow!!

 

[ShaunCorbs]

Some quality work there Corbs.
Don't envy the church job that pipe work looks massive.

thnx and 2" iron and had to be dug out by hand over 3/4 tn by hand bad day that day, org pipe was like swiss cheese, and the second was a 2-4" reducer

 

[solutions]

sorry solutions, that one made me chuckle....
why pull a bend on the blow off then solder a joint anyway?
could have just used elbow!!

The top portion is a preformed tail but the layout of the vailant means the space behind the blow off has to be kept clear to allow the condense trap to be dropped out.
it sits forward of the other tails so I prefer to loose the corner with a bend.

 

[REDSAW]

The top portion is a preformed tail but the layout of the vailant means the space behind the blow off has to be kept clear to allow the condense trap to be dropped out.
it sits forward of the other tails so I prefer to loose the corner with a bend.

oh yea, see the hole now..good thinking batman