Search the forum,

28mm polyplumb

Post new thread

Discuss 28mm polyplumb in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

smhstu

As the title says, got a load of 28mm polyplumb fittings. All complete, mostly they are tees(sack full) some elbows and couplers
open to offers
i will put numbers on if anyone interested, will split.

cheers
 
I had some surplus of these and sold them in packs of 10 on ebay for only slightly less than the new price on Buy It Now basis
 
Status
Not open for further replies.

Reply to 28mm polyplumb in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Any advice for putting this shower in ?
Hi All, Looking for some advice on my little bathroom project. I took the bath out. I got a shower jacuzzi thing. The base has 2 wheels in the corner. Do I assemble the unit first attach water and elec, and slide the very heavy unit in on the two wheels? Or do I get the base in the corner and...
Replies
2
Views
109
Staggersandfalls
S
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
300
exedon2
exedon2
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
172
Lou
Lou
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
176
Lou
Lou
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
219
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

TilersForums.co.uk | UK Tiling Forum - Est 2006
Tilers Talk
Tile Cutters
UK Tiling Forum
Tiling Tools
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock