Hello,
I’m having a bit of an issue trying to fit a mixer shower bar, the pipe centres are around 3/4mm too narrow! I’ve attached a photo below, is there a simple fitting I can by to narrow the pipe centres by a few mm?
Hi, I have a shower which has pipe centres of 110mm. Looking for a new shower but it looks like all the modern showers have a pipe centre of 150mm. Is that correct and if so, is the only solution to replace the plumbing?
Thanks in advance
Ian
Hi,
I have to replace a Mira Realm shower valve, it is dripping and I cannot get it apart to change o rings etc. The pipe centres are 180mm does anyone know of an exposed shower valve suitable for low pressure water systems that has 180mm pipe centres?
Thanks
I have a traditional British bathroom sink with 2 separate taps for cold and hot water. I need a bridge mixer tap for it. The problem is I only seem to find ones with 180mm tap connection centres, while mine needs 200mm. IS there hope?
Hi guys. Do any of you guys know of any training centres in the West Mids or close to Stratford upon Avon? I was hoping to get into Swat gas but they’ve ran out of spaces.
I had a plumber start the renovation of my bathroom but he had to be dropped off the job for making several mistakes.
He has fitted the bath and loo, but not the shower nor the basin. He has done the pipework for the shower. Chased the wall out and used 15mm copper pipework. Wall has been...
Hi, I'm looking for a concealed thermostatic valve with 22mm inlets and 150mm centres. Something with a brass construction but not £300 or over. I'd be very grateful for any help!
thanks,
Ben
Hi all, ive installed a fair few ufh systems now, all of which are onto oil boilers. Im starting a ashp system next week and was wonderimg how you all loop the pipe to 150mm centers. So far ww have hand formed the loops to 200mm centers but im not confidend of hand forming beyond that!! Does...
I need to swap an exposed shower mixer, it has 125mm pipe centres which is a new one on me, only seen 150 centres before. Can anyone recommend any? Its for a landlord so they aren't going to want to spend loads.
Hi,
I've come across a few thermostatic shower mixer valves where the technical spec states the inlet centres are 150mm (+- 5mm). What does the +-5mm mean, if on the valve body the distance of the inlet holes are fixed at 150mm.
Does it mean that the inlet centres on the wall can be between...
Hi,
I want to fit a shower mixer tap to my bath but the bath holes centres are 185mm. All the mixer taps I've seen so far require tap centres of 180mm.
Would I be able to get away with fitting a 180mm mixer tap to 185mm centres?
Is there any adapter or fitting that I can use to accomodate...
Hi guys,
basically looking for value for money ACS training & assessment centers for re-taking my ACS. there is one very local "Kiwa GASTEC" but they want a wopping £1200 (3days training & 3days assessment). I have had a cheaper price from what seems to be worcester-bosh but only 2days...
Quick question guys/gals. Kudox rads, how much to add to the width of the rad for the pipe centres? 90mm for a lockshield and TRV set? Not normal for me to first fix without rads there so would appreciate advice from those who do it regularly. Thanks!
Hello,
I need some advice on my DIY wet under floor system I installed in my new build house.
Basically I have fitted JS speedfit15mm pipe into 100mm insulation foam board by routering the pipe slot into the foam and then pressing the pipe into the foam slot at 200mm centres.
I then...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.