Search the forum,

Danfoss HSA3 Motorised Valve

Post new thread

Discuss Danfoss HSA3 Motorised Valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

L

Lisa hood

Messages
5
Could anyone please offer any advice on the wiring positions for the new valve, the old valve has numerous wires so I'm now unsure of the positioning for the new, please see attached pictures, all advice appreciated

20181210_131958.jpg


20181210_145833.jpg
 
There still wired up so remove one at a time and replace them with the same colour
 
House is still standing just about was just delayed in replacing, so I fitted the new part and set it to manual, pressed heating and the boiler fired up which it wasn't doing b4, nothing happened with the radiators so I tried to bleed the pump, I think I managed it as some water came out. Now only one radiator which is closest to the system is Luke warm, I've bled the others with no joy, also the pump it too hot to touch when the system is on. Any advice?
 

Reply to Danfoss HSA3 Motorised Valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
238
exedon2
exedon2
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
317
Timmy D
T
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
190
SimonG
SimonG
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
182
ShaunCorbs
ShaunCorbs
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
221
oz-plumber
O
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock