Search the forum,

Powercleanse Radhammer..... How much???

Post new thread

Discuss Powercleanse Radhammer..... How much??? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

W

Wirdy

Messages
30
Couldn't justify £30-£40 for something so simple........ So araldite+cut down sds bit +spare nylon hammer head=pennies ☺️
2018-11-28 22.49.06.jpg
 
Won't last as snapped a few adey hammers
 

Reply to Powercleanse Radhammer..... How much??? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Y Plan, no hot water but heating is working when called
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
238
John.g
J
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
316
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
182
dreikher
dreikher
C
Mira shower mixer adjustment.
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
224
cheddarman
C
U
Below Ground Soil Pipes on Self Build Bungalow
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
82
umiq88
U
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock