Search the forum,

Discuss Bottle Auto Air Value in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
9
I need 3 auto air value for my CH system. Any suggestions to a good quality 15mm product. I was going to buy the unbranded screwfix ones but some of the reviews are terrible.

Thanks folks.
 
Put a decent lever valve before the auto air vent. Will make future maintenance easier. They all leak sooner or later.
 
there not designed to be left open you know so you will have to close / tighten the bleed screw?

have a look at a sprio rv 2
 
As above really. Most cheap AAV's will leak eventually and become a nuisance or do damage. There is a Commercial one I do rate quite highly but it will cost a pretty penny and probably be overkill on domestic. I would go for the manual as other suggest. Once vented a system should not suffer with air issues, as long as it has been installed correctly.
 

Reply to Bottle Auto Air Value in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
316
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
224
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
284
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
229
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
182
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock