Search the forum,

Vaillant ecoTEC plus 831 gc 47.044.32

Post new thread

Discuss Vaillant ecoTEC plus 831 gc 47.044.32 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
E

ed209

F .61 fault says poss gas valve control faulty amongst other things any advice on most common problem please
 
Check the harness for continuity and make sure all earthing is good on boiler
 
If it is ecotec 2 with air mass meter/stepermotor gas valve it will be a harness issue. If ecotec 1 2004-2012. it will be PCB issue. see the boiler sticky page 7 for the video.
 
Status
Not open for further replies.

Reply to Vaillant ecoTEC plus 831 gc 47.044.32 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
163
Lou
Lou
C
Y Plan, no hot water but heating is working when called
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
322
John.g
J
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
289
oz-plumber
O
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
292
exedon2
exedon2
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
157
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum
Tiling Tools
Tiling Forum
Contractor Talk
TilersForums.co.uk | UK Tiling Forum - Est 2006
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock