Search the forum,

Discuss Thorn Apollo.......but which one? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gassius clay

Hi guys I came across a thorn apollo today and it needs some parts but has no GC number or anything to identify it.All I can say is it is probably as old as me.How on earth do I find out what model it is. Any help would be appreciated.Thanks
 
Hi guys I came across a thorn apollo today and it needs some parts but has no GC number or anything to identify it.All I can say is it is probably as old as me.How on earth do I find out what model it is. Any help would be appreciated.Thanks


you will be lucky to get any parts for that mate
 
Did you look in bottom cover ? sometimes its inside combustion chamber or on side , look under Myson they took over Thorne. What parts you after ?
 
Did you look in bottom cover ? sometimes its inside combustion chamber or on side , look under Myson they took over Thorne. What parts you after ?

I thought Thorn were part of the Baxi group now?
There should be some parts lists and a manual on Parts Arena.
 
Isn't the databadge on the combustion chamber door on these? Seem to remember it being riveted on??
 
i can get a new data badge for it. but which one is it lol.

here is a part no 402C2226
 
Hi guys I came across a thorn apollo today and it needs some parts but has no GC number or anything to identify it.All I can say is it is probably as old as me.How on earth do I find out what model it is. Any help would be appreciated.Thanks
still get gas valves / thermocouples and may be the pilot assy dont think you will get much else
 
I'm fitting a pump overrun to one next week. They came in 3 sizes far as I remember 15/30, 30/50 & 65/80. The o/heat stat was the part that varied the most unless it's something specific to the 'boiler size' you're after?
 
The data badge was a sticker, that has crumbled away due to the heat from the combustion cover. Seen it loads of times.
 
This is where I get confused, the OP is not GSR so how come we are talking about looking in/around combustion chamber etc etc?
 
Thorn Apollo. I have one still running at my home. What parts you looking for as they don't have too much parts inside.
 
Status
Not open for further replies.

Reply to Thorn Apollo.......but which one? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
140
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
213
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
138
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
302
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
268
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock