Search the forum,

Discuss Spirotrap or Magnaclean?? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Nas

Plumbers Arms member
Plumber
Gas Engineer
Messages
137
Which is better in your experience Magnaclean or Spirotrap??
Are there any advantages of one over the other?
 
Spirotrap.......I work for a well known reputable company who are in the middle of a court case with magnaclean as after installing thousands of them do not believe they work very well.
 
Is spirotrap the same as spirotech?

If so then.....

Magnas do a go job with the filtration but are very prone to leaking canisters and isolation valves due to the moving parts having crappy o-rings. However having the iso valves gives a certain amount of flexility when fitting.

Spirotech have no o-rings(as fas as I'm aware) therefore less prone to leaking but they don't have isolation valves at all which obviously come in handy if said filter had to be replaced for some reason especially on an open vented system. Also having no iso valves gives it no flexibility when retro fitting to a system, it's all well and good fitting one to a new install but the problem arises as I say when retro fitting and there may be no play on the pipes to get the filter into place.

These are my pros and cons for the 2 anyway for what it's worth bud
 
And me, fitted loads, never had a problem... does exactly what it says on the tin..


Even got a little demo jar to show the customers…. as for the Spirogyrothingymabobs not got a scooby.....
 
magnacleans for me, no probs apart from a minor leak a spanner cured easily, only issue was a customer removing the lid without turning off the valves, lol, rang me to have a rant, until i pointed out that i had shown him where the instructions were and that i had demonstrated how to clean the magnet because he insisted on cleaning it himself every 3 months???, still now its being cleaned annually when i service his boiler as his wife doesnt want wet carpets again.
 
Magnacleans so far. Fitted loads of them and no problems yet.
 
Iv'e used loads of Magnacleans & never had a problem, apart from the thin flimsy olives in the compression fittings that I now wrap up in PTFE.
I've read a lot about the Spirotechs however & have got one in the van to try on a particularly grotty system :D Its a real solid lump of a unit

My merchant however says they get lots of Magnaclean complaints (don't know why :confused: ) & that magnacleans are only guaranteed to 2 bar, which would render the guarantee pretty much useless on a sealed system :eek:
 
My custard's snapped the red isolator valve top off, have emailed magnacleans dudes but wondered what the forum thinks of making a new connection up with service valves and 22mil comp fittings? never dealt with these before.

Any ideas?

Ta
 
Status
Not open for further replies.

Reply to Spirotrap or Magnaclean?? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
204
P
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
213
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
480
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
252
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock