H
heatman
Last edited by a moderator:
Discuss Sample Gas ACS questions in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
P
Puddle
Bit of a out burst there
Do you feel better now you have got that off your chest heatman
Do you feel better now you have got that off your chest heatman
L
lennytheloon
Hi lads.
I have to ask, but do you have permission to post those questions on the forum. Are they protected by copyright??
We had a problem on the sparks forum with course notes and past papers which we had to remove.
Cheers
Thanks Heatman.
I have to ask, but do you have permission to post those questions on the forum. Are they protected by copyright??
We had a problem on the sparks forum with course notes and past papers which we had to remove.
Cheers
Thanks Heatman.
Last edited by a moderator:
H
heatman
Oven thermostat which goes out at by-pass rate
A oven thermostat by-pass may become blocked, causing the flame to go out when the oven reaches temprature and the flame size reduces down , for example gas flow is interrupted through the bypass
the answer here is to clean the by-pass orifice screw. reassemble and check the cooker operation. when cleaning be careful not to enlarge the orifice to the bypass.
A oven thermostat by-pass may become blocked, causing the flame to go out when the oven reaches temprature and the flame size reduces down , for example gas flow is interrupted through the bypass
the answer here is to clean the by-pass orifice screw. reassemble and check the cooker operation. when cleaning be careful not to enlarge the orifice to the bypass.
Last edited by a moderator:
N
newbie1
understand now the question is perhaps not worded well
i get it the thermostat drops the flame when it reaches a set temp but keeps it allight via the bypass
as opposed to doing a manual test when oven is hot of turning flame down to see if it stays allight on low
whereas if flame supervision was faulty gas wld still stay on low i suppose via the bypass
couldnt blve that the gas still gets in even if the gas valve shuts via a bypass when i asked my instructor didnt seem to make sense that gas still flows if a flame goes out??
i get it the thermostat drops the flame when it reaches a set temp but keeps it allight via the bypass
as opposed to doing a manual test when oven is hot of turning flame down to see if it stays allight on low
whereas if flame supervision was faulty gas wld still stay on low i suppose via the bypass
couldnt blve that the gas still gets in even if the gas valve shuts via a bypass when i asked my instructor didnt seem to make sense that gas still flows if a flame goes out??
B
bill1
hi does anyone no where i can get some acs sample questions
M
mikimac
PM Kirkgas on this site & give him your email address & he will help you out :stooge_curly:
B
bill1
thanks
J
Jay23
How do I find KirkGas on here?
S
stoker122
If you call him he will come grasshopper.
O
on31ll
Go to you inbox on the forum and click new message and enter kirkgas and his name will come up then send him a message !
Or wait and he will appear !
- Status
Reply to Sample Gas ACS questions in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
- Locked
Hi, Im still on a learning curve here and would appreciate a little info on servicing procedure / landlords safety check for Gas hobs / cookers...
- Locked
Hi ,
Here are my question and would appreciate some help and advice.
I am new to the buisness and am a little green .
1
How do you check...
- Locked
Situation:
I own a lovely sleek contemporary NEFF GAS hob its about 3 years old. And of course during the use of this appliance we will put a...
- Locked
Anyone looking to become a plumber should aim for these
Firstly (4 Years Day Release or Fast Track Company in about 24 weeks in total): -
6129...
