Quick answer on mid position valve fault please

[OffshoreGas]

Cheers, seen that though

Which bit is it your not sure about? What the bits in the circuit diagram above are for or what’s actually in the valve body?

 

[Burger]

He’s not been back with the multimeter yet, so maybe it’s a case of wait and see?

Wiring diagrams, check.
Internal operation and resistance values, check.

 

[Sharp Point]

Which bit is it your not sure about? What the bits in the circuit diagram above are for or what’s actually in the valve body?

Until I go back to the job and go over the wiring( re-wire centre) to ascertain proper termination and tightness, there isn’t a pressing issue ....yet. I could be like TFJ says ‘ a loose wire’
If it’s not a loose wire, what is keeping power at the synchron motor to burn it out in 3 months, seems the old tower valve has suffered the same death.. but maybe lasted a lot longer( I dunno, maybe metal gears) where as Honeywell maybe use plastic.

 

[Sharp Point]

Anybody know the resistance across a known decent synchron motor, for reference

 

[Burger]

Anybody know the resistance across a known decent synchron motor, for reference

I haven’t used my free Corgi-direct one yet, I’ll test that when I have a spare minute, if you want?

 

[OffshoreGas]

Anybody know the resistance across a known decent synchron motor, for reference

Just the motor should be 2.2k or there abouts.

 

[Sharp Point]

I haven’t used my free Corgi-direct one yet, I’ll test that when I have a spare minute, if you want?

Lol, yeah I forgot about that..... we’re the fortunate ones

 

[Burger]

Lol, yeah I forgot about that... we’re the fortunate ones

Have you still got yours then?

 

[Sharp Point]

Have you still got yours then?

Nah, I used it a few days after I got it. It’s the same one I usually buy from an independent, but got that fancy corgi sleeve on it