Search the forum,

Need to fit new Radiator Valves

Post new thread

Discuss Need to fit new Radiator Valves in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

BAPCOAWALI

Messages
1
Replacing old radiator, valve connection badly corroded, had to cut pipe below compression ferrule.
Require to extend pipe to position radiator in original position, advice please
 
If you cant solder then use Tectite push fit , made of copper and slim fit, but use pipe cutter as you need a clean bur free edge
 
Status
Not open for further replies.

Reply to Need to fit new Radiator Valves in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
287
exedon2
exedon2
B
What is correct toilet supply line
Hi. I need a new toilet supply line but donā€™t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
206
ShaunCorbs
ShaunCorbs
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
220
ShaunCorbs
ShaunCorbs
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
291
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
211
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

TilersForums.co.uk
Contractor Forum
UK Tiling News
Plumbers Forum - Plumbing Advice
Plumbers' Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock