Megaflo with internal air bubble.

[jase158]

Mega flo 170l, leaking from t&prv, drained down and refilled to recreate air bubble, still leaking, all thermostats/ valves working.
grenade style valve, leaks when water reaches 50 degrees.

Books say that they can be adjusted but i cant see how!!
also how do you know that it isnt the baffle in the cylinder that is broken?

I am G3 registered!!

 

[SafeGasInstall]

new T&Prv valve

 

[jase158]

just needed to confirm, thank you. changed the thermostat a month ago, all working fine then suddenly this goes and thermostat has gone again!!

 

[SafeGasInstall]

if the thermostat is gone is likely that is over heating , how did you read the 50 degrees temperature ?

 

[jase158]

sorry was the immersion thermostat that has gone, cylinder thermostat is what i got reading from, t & prv drips at 50 degrees, broke my thermometer so couldnt tell reading at tap but it wasnt hot enough to burn. I am just curious how do we know its not the baffle inside the cylinder? is the only way to test it by putting new t & prv on?

 

[SafeGasInstall]

does it drip when you pressurise it or when start heating it ?

 

[SafeGasInstall]

I dont think the internal baffle can fail , how old is cylinder ?

 

[jase158]

Only when temp reaches 50 - 55

 

[SafeGasInstall]

http://www.heateam.co.uk/docs/replenishing-air-gap-print-instructions.pdf

 

[SafeGasInstall]

see the link , did you do it like this ?

 

[jase158]

12 years old

 

[jase158]

Kind of, but after that I also drained it fully as did the pressure relief last time and was hoping that it hadn't worked and by draining it would solve problem, thinking about it, that might of cracked the seal. By doing it the first time and causing it to leak when water is heated putting pressure on it???

 

[Poxi]

If its been dripping for a while the seating on the T & P valve will be scored, Hence fit new one..A little tip, make sure when you push the T & P in the probe is below the baffle. You will see it if you shine a torch through the 1/2 inch hole.

 

[lbp plg & htg]

Internal baffle can fail. it can have a pinhole/s which can cause failure or I have even known the baffle to fall of the end of the plate which holds it in position.

 

[SafeGasInstall]

Would that mean new cylinder under guarantee ?