Search the forum,

Discuss freezing of pipe in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

don bagting

Hi.
I,m new in plumbing can anyone can tell me how thw best idea to freeze the pipe because i want to change my isolation valve in my house.
thanksand regards to all member.

Cesar
 
freezing pipes is ok for heating systems but not so good for mains pressure so if its just the domestic water turn the water off and drain the system
 
I second that good advice... I thought I would try to freeze mains water once , because I know best etc. I ended up with a bullet hole in the plasterboard wall where the ice plug shot out after i had cut the pipe. It was the quickest I ever put an ballofix on, in my whole career. Don't do it on mains. Thank god the customer was out and I mopped before anyone knew. Reason I did this was because the mains outside Stop tap was buried in silt, and the house valve was seized. I was being lazy. Never again.
 
don't use the canned freezing kits from b&q use a desent mains pipe freeze.
they will freeze alot longer and over a bigger area.
 
Thanks to all of you, really appreciated. i will try to isolate it in main pipe.
 
Status
Not open for further replies.

Reply to freezing of pipe in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
243
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
136
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock