Search the forum,

Expensive ceramic cistern with crack/chip at inlet hole.

Post new thread

Discuss Expensive ceramic cistern with crack/chip at inlet hole. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

K

Katherine

Hi, we have an expensive ceramic cistern with a crack/chip at the inlet hole; can the cistern still be used?

Thanks 🙂
 

Reply to Expensive ceramic cistern with crack/chip at inlet hole. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
253
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
139
Lou
Lou
U
Below Ground Soil Pipes on Self Build Bungalow
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
116
umiq88
U
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
213
mutley racers
M
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum UK
Tiling Standards BS5389
Electricians Talk
Tile Talk
DIY Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock