Discuss Bleeding my Oil Boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
2
Hi There,

We ran out of oil....more or less.

I believe the oil boiler now needs bleeding, as it will only come on for a minute or two, often less, then it turns itself off. Pressing the reset button means it lights again for anywhere between 30 seconds and 2 minutes, but no more. There's mild heat in the radiator, but very mild.

Because of having the tank refilled today, I presume this is a bleed issue, but I may be wrong. It was serviced only a fortnight or so ago.

I have taken some photos of the boiler - it says the make is Beta (it's old!).

1. Can anybody point me to where I would find the bleed valve?
2. Can anybody remind me what the red dial is for? I remember being told by our original heating engineer, before he retired.

Have had issues with the motor in the 2-way valve in recent times which was causing house and system to trip, but have mostly resolved that without replacing it. The last thing the heating did, though, when the oil ran out, was trip the circuit...

Any help greatly appreciated. Would prefer to learn to bleed this myself.

IMG_0489.JPG


IMG_0490.JPG


IMG_0491.JPG


IMG_0492.JPG
 
Please don’t touch the rad dial. It’s for air adjustments.
You photos don’t show the bleed nipple, as it’s on the side of the fuel pump.
I would recommend paying someone to come and sort this, as there could be up to six ports on the pump. One will be the pressure adjustment screw. Move this and you could soot up your boiler.

If your adamant to do it yourself. You could remove the burner and disconnect the oil line. This will purge the oil, but without isolating the supply, you might have a lot of fuel to mop up.
 
Last edited:
On a side note. That probe should be clipped just above the burner.
 
Get your service guy back and get him to show you what to do.
Don't keep pressing the reset, and as Chalked said don't fiddle or it could turn into a more expensive visit.
 
Good burner that, although it is probably getting on a bit.
That oil pump can be a difficult one to bleed, so best get your service guy to sort it and show you.
Running out of oil can finish a worn oil pump, so you could also have a fault.
 
Thanks for all this. Will get the boiler service chap back and just watch this time. And hopefully not have the problem in the future....
 
Status
Not open for further replies.

Reply to Bleeding my Oil Boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Oil boiler (now~15 years old) unvented system with 17 radiators. We moved in 5 years ago and I had to keep bleeding the same radiator. The bleed...
Replies
1
Views
265
Hi My oil boiler keeps locking out after running for 30/40 minutes! I then try to reset it but it won’t fire back up! I have to leave it for...
Replies
19
Views
857
Hi, Over the past few months, my wife and I have noticed a constant pulsing sound throughout the house which is particularly noisy at night (this...
Replies
4
Views
679
Context for issue: Last winter the temperature switch on my boiler shorted somehow, the boiler was then running WAY too hot and ended up...
Replies
6
Views
604
Hello, I am looking for a heating engineer to diagnose and resolve an issue with my Vaillant EcoTec 832 combi boiler. Job Location: Copeland Rd...
Replies
1
Views
424
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock