My Irwin pipe bender has lost the retaining nut for the central bolt and the 12mm we have on site aren't the right pitch.
Does anyone know what type of 12mm nut to get?
Irwin don't, I've asked.
No replaceable parts on their benders.
Dear all just bought this and tried to install yesterday.
Item is rubbish. Washer missing from bt which is needed to stop bolt turning. Other 3zwasher badly made and don't got bolt heads.
Spent ages making own new washer and hammering bits to fit washers.
In hindsight should have returned...
Evening All,
I've just had a mare of a day digging up a kitchen floor trying to re-route pipes. Can anyone recommend some kind of pipe detector that will detect pipes in concrete?
Jock
Looking to get one of these for a while and just got a job that's perfect for it to save me a fat drain down on a very old property, which one do you guys who use them rate, this place has 28mm return so ideally something suitable for that. Cheers.
View: https://www.youtube.com/watch?v=i3ae5gPyLhQ
I like it...needle bearings everwhere, less stress on the hands, rock hard cutting wheel + spare, one size required and no pipe deformation.
Yes I know topic has been covered umpteen times but here is another. Has anyone experience of the Rigid 32573 supposedly goes from
6mm up to 28mm? Only asking as a bit fed up with my Kopex ones, I only do a bit of DIY cutting but have 3 sizes 15,22 and 28. The 15mm is shot
the 28 is plastic and...
Just got myself a new 15/22mm pipe bender and am looking for a container. I have seen a couple of bespoke bags, but would rather a solid case of some form, if available.
Any ideas or pointers as to a suitable solid container?
Hi all
Hope everyone is staying safe. Need a little help as over the past few years I have kept my pipe slices in all kinds of containers but have ended up getting broken or just takes too much room in my install bag. Anyone, come across anything decent?
Thanks
Hi Guys,
I'm looking to purchase a 40mm PVC/Plastic pipe cutter, i have a ceapy chinese ratchet type one but the ratchet system is broke, plus a 40mm pipe barely fits into it.
I will be doing a lot of floplast or polypipe solvent 40mm cuts (not sure which atm, whoever is cheapest and does...
hi chaps - thinking about investing in one - not sure to go rothenberger or arctic products...any suggestions? pros and cons? much appreciated! thanks dave
I'm trying to find a spindle pin for this bender. This is the 19mm pin which goes through the quadrant bit then the bender frame, the bending arm, and out the other side. Irwin UK have told me this is only available as part of the quadrant assembly (Part No.T220H in their catalog, or part H in...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.