Un-sleeved gas pipe, landlord saftey check.

[ShaunCorbs]

Isolate supply mate

how do you isolate the install?

 

[Harvest Fields]

just with with sleeve theyve upgraded it from ncs to ar which i dont agree with

Sleeve has been AR for years when it is straight off the gas meter.

 

[Harvest Fields]

how do you isolate the install?

By the appliance spur or Gas tap/ECV

 

[ShaunCorbs]

By the appliance spur or Gas tap/ECV

so ar is cap the supply

 

[Harvest Fields]

so ar is cap the supply

Nope, because you remove the fuse from the spur or turn the gas tap to off position or pull the ecv to the off position (this is not a cap as you can Turn it back on with minimum effort). When you cap something you are disconnecting it from the supply. You only disconnect on an ID. NOT AN AR.

Edit due to bad grammar

 

[Harvest Fields]

If eventually we solve this and I am wrong. I will apologise for being wrong. But at the minute I am standing my ground on this one.

 

[sammathias]

how do you isolate the install?

Yeh I get where your coming from I think. If you can't isolate supply appliance without isolating whole install affecting other appliances then you would can it at appliance but that's quite a rare occurrence...

 

[Harvest Fields]

Yeh I get where your coming from I think. If you can't isolate supply appliance without isolating whole install affecting other appliances then you would can it at appliance but that's quite a rare occurrence...

But that isn’t what the GIUSP say. That is an isolated instance that you would deal
With when in that position.

 

[sammathias]

Ok so a.r is isolate appliance and i.d is disconnect and cap...both with warning notice.

 

[Harvest Fields]

Ok so a.r is isolate appliance and i.d is disconnect and cap...both with warning notice.

Ok so a.r is isolate appliance and i.d is disconnect and cap...both with warning notice.

That’s what I think. But I am getting told otherwise on here.