Testing concealed shower valve

Post new thread

Discuss Testing concealed shower valve in the DIY Plumbing Forum area at PlumbersForums.net

K

kristeva

Messages
28
Hi all

I've finished running the copper for my concealed shower valve and tested both inlets and the outlet with cold mains (full pressure).

I just wanted to ask is it considered necessary to test the hot inlet with hot water, or will the cold suffice?

Many thanks

P
 
Colds fine
 

Reply to Testing concealed shower valve in the DIY Plumbing Forum area at PlumbersForums.net

Similar plumbing topics

K
Running copper pipework above / across a Gas boiler?
Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath...
Replies
2
Views
219
kristeva
K
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
219
Lou
Lou
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
218
Lou
Lou
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended...
Replies
6
Views
302
Dave Moore
D
D
Replacing outdoor P-Trap Gully with Bottle Gully
Hi all, I'm installing a concrete patio out back. By the wall under the kitchen sink I have an existing P-Trap gully for the grey water from the...
Replies
0
Views
178
DIwhYdidIstartThis
D

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock