Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Sorry do you need GS in every post in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

mickytwohammers

Sorry i did put G/S 217929 in post my first post did i do it wrong
does it need to be in every post




Wilo pump RS15 when central bleed screw is removed lots of water shoots out

rather than a dribble does this mean impeller is not spinning boiler is restarting every 30 seconds
any clues please
 
When you get to ten posts please send a copy of your gsr card to [email protected].

You can apply for access to the private forum where we'll answer this.

Not on open forum.
 
Status
Not open for further replies.

Reply to Sorry do you need GS in every post in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
253
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
425
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
201
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is...
Replies
5
Views
541
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
304
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock