Soldering

Post new thread

Discuss Soldering in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
i cant see any problem with it, ive soldered right next to valves all the time, every boiler i fit,
although i try to avoid if possible but ive never had a problem, just open the valve if possible and put a wet rag on it straight away
 
New posts
Status
Not open for further replies.

Reply to Soldering in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
241
dreikher
dreikher
K
Frustrating problem with stuck End feed Tee
Hi guys Bit of frustrating situation, I was preparing to solder a 15mm Tee by lining it up to get the positioning right, etc and it was quite...
Replies
4
Views
196
kristeva
K
P
    • Like
Need Help on Shower Drain
Hi, I need some help on this shower drain installation. I’m about to install a corner shower kit in my basement bathroom. But I just found out the...
Replies
9
Views
801
Lou
Lou
D
Soldering poorly fitting joint - pipe not round, good fill, how?
Hi, Short version: I have about 4" of pipe sticking out of a concrete floor in a cupboard. It makes a 45-degree bend as it exists (bent, not with...
2
Replies
14
Views
1K
gmartine
gmartine
B
What would this odd 22mm-32mm adapter be known as?
I have a CH boiler installation with a nice simple vertical condensate drain, down and out through the wall to a pipe outside. All is as it...
Replies
8
Views
496
ShaunCorbs
ShaunCorbs

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock