Search the forum,

Discuss Pump House Condense pump in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Harvest Fields

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
10,444
Has anybody had any experience with one of these. After some genuine feedback. Been asked to quote to fit a combi in a 2 bed semi and remove a powermax 155x. But the powermax is in the centre of the house and it has 19mm boarding on the floor, not floorboards. Do not want to try and take the floor up for the condense or PRV. These say you can run both through their pump???
 
Last edited:
Yep very good have a few coming up 5 years no problems touch wood

IMG_1092.JPG
 
Cheers mate. The rep said the new one goes to 100dc. And as I said before mate. Yorkshire fittings? You must be made of money:p:D

That's when I was an apprentice :D
 
That’s better pipework then I do now mate. Looks awesome. Where do you get your pumps and fittings from?
 
That’s better pipework then I do now mate. Looks awesome. Where do you get your pumps and fittings from?

Apart from when I piped the hot and cold the wrong way :D :D

That set was from pts back then I think the pump cost around 280 plus
 
Status
Not open for further replies.

Reply to Pump House Condense pump in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
232
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
192
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
245
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock