Pressure testing 63mm gas pipe

[mutley racers]

I have been asked to pressure test and cap of 12metres of 63mm yellow gas pipe that is in a trench. Nothing is connected to either end.

Pressure testing to 10 bar should be fine hey?

 

[mutley racers]

try these they will be cheaper
Modus Gauges Limited

Works out around 3 quid more due to carriage. Thanks though

 

[quality]

worth a try

 

[mutley racers]

So went to pressure test this job but the pipe was not installed to regs. They had run yellow mdpe into the building which if I remember correctly is a no.

I do know the gas board do this though when replacing the mains to the meter inside the house with mdpe by pushing it up the old pipe.

 

[Scott_D]

So went to pressure test this job but the pipe was not installed to regs. They had run yellow mdpe into the building which if I remember correctly is a no.

I do know the gas board do this though when replacing the mains to the meter inside the house with mdpe by pushing it up the old pipe.

Any pics?

 

[ShaunCorbs]

into the building is ok under the building no no

 

[mutley racers]

Any pics?

Not the most revealing to be honest. Not much to see.

The pipe goes under the building just to the left