Discuss poor heat from rads downstairs in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
1
Help needed please. I had a combi boiler installed with some replacement downstairs rads. There was a system flush and a magna clean fitted. The problem is the downstairs radiators will not heat up much. They wont go beyond lukewarm. The upstairs ones get lovely and hot. There is no air in the system and the balancing is correct. I have tried turning upstairs rads down and even shutting them off completely. The downstairs rads remain lukewarm. I have also tried turning up the pressure but the problem remains. The pipes to the rads are quite warm but not overly hot.
I would appreciate any suggestions please ad my family are fed up of going to sit upstairs to keep warm in the evenings despite the mild weather.I should have said that the installation was in May of this year so we didnt use the heating at that time. But we have only recently began to put the heating on as we havent needed it due to the recent mild weather. Also we had worcester bosch out as it is under a guarantee but they cannot find a boiler fault. So I am wondering if it is a system layout fault. Our 25 year old standard floor boiler kept all of the rads very warm.
 
Last edited:
i would say as its just been installed get the installer back
 
did you have new trv's fitted?
sounds like they are one directional and there is a flow cross-over to the downstairs rads!
 
Status
Not open for further replies.

Reply to poor heat from rads downstairs in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
196
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer...
Replies
4
Views
280
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up...
Replies
2
Views
262
PSxxxxxx
P
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
366
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
195

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock