Search the forum,

modulation range

Post new thread

Discuss modulation range in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

damaan

Sorry I keep reading about modulation range for combi boilers: what is it? What is a good one?
 
For instance, Baxi quote a 1:7 modulating range.

That means a 28 kW Baxi boiler can modulate down to 4 kW heating output and still operate without cycling.
 
Status
Not open for further replies.

Reply to modulation range in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
196
ShaunCorbs
ShaunCorbs
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
221
oz-plumber
O
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
316
Chuck
C
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
182
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
185
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock