Search the forum,

Mcs

Post new thread

Discuss Mcs in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

james the plumb

Hey guys.I'm sorry if this has been asked before but how much is mcs???And what do you have to do. I've read so much I jus want it in laymans LOL
 
Eaton has just gone through it, if you PM him he will be able to advise you as it is all very fresh in his mind
 
Status
Not open for further replies.

Reply to Mcs in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
122
Lou
Lou
B
Posting a thread as until now I've only read the forum
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
0
Views
40
Bob Kerr
B
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
186
Timmy D
T
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
257
oz-plumber
O
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
324
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electricians Talk
Electrical Forum for Electrical Advice
UK Tiling News
UK Tiling Forum
Tiling Standards BS5389
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock