Search the forum,

Lucky couple of guys

Post new thread

Discuss Lucky couple of guys in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
jonnyswamp

jonnyswamp

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,826
Status
Not open for further replies.

Reply to Lucky couple of guys in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
    • Friendly
Posting a thread as until now I've only read the forum
Hi, I've followed this excellent forum for several years but have never posted, so decided I'd better give some details. My status is the upper end of DIY and I've a couple of house renovations under my belt (my own homes) I am retired but do volunteer handyman jobs for the elderly. Not...
Replies
2
Views
176
turnpin
turnpin
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
219
dreikher
dreikher
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
557
Chuck
C
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
6
Views
233
127bit
127bit
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
176
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Contractor Talk
Tiling Tools
Tiling Forums UK
British Standards in Tiling BS5389
Tilers Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock