Search the forum,

Discuss Joining existing waste pipe in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Kus

Messages
11
im planning a separate shower cubicle and currently have my bath and basin joining into a 50mm waste pipe to the outside stack. Can I tee in my shower to the existing pipe. If not going to have to raise tray by 100mm due to joist layout.
 
im planning a separate shower cubicle and currently have my bath and basin joining into a 50mm waste pipe to the outside stack. Can I tee in my shower to the existing pipe. If not going to have to raise tray by 100mm due to joist layout.
2” should cope as long as you do not pull the the bath, basin and run the shower all at once. But to be honest I would probably run a seperate one as you wouldn’t want the shower tray to back fill.
 
Is it possible to take the bath out of the 2" and run new for that?

Then join the shower to the 2"
 
Don’t fit a shower to a bath waste pipe.

If there’s a down stream blockage, or you don’t have a great pipework set up your gonna backfil that tray.

Many will say it works, so it’s fine, but I would never do it. Basin and shower, yes, not so bad as the volume of water is far less likely to cause an issue, but that still has to be piped well!!
 
I always run a new waste for a shower tray and never connect to a bath waste the vacuum caused from the bath emptying can pull the water out of the shower waste trap and bad smells from the sewers can come into the house. And there is a good chance that in the event of a blockage or there is not a very good fall that the waste / foul sewerage water could back fill in to the shower tray.
 
The length of 50mm to the outside wall is 1.8 metres and the shower would tee in at 1 metre before the pipe exits the walls into the soil stack. Would this still cause a problem due to the short run.
 
The length of 50mm to the outside wall is 1.8 metres and the shower would tee in at 1 metre before the pipe exits the walls into the soil stack. Would this still cause a problem due to the short run.
Like I said above mate. If it was my house I would run another waste or as someone else said above give the bath it’s own.
 
Status
Not open for further replies.

Reply to Joining existing waste pipe in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
100
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
118
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
232
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
227
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
264
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock