Search the forum,

Grab Your New 17 Plate Van Now with Vansdirect!

Post new thread

Discuss Grab Your New 17 Plate Van Now with Vansdirect! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

Tim.

VD_17plate_event.jpg

If you have any questions on the offers available, please drop me an email at [email protected] or complete a Contact Us form on the Vans Direct Website
 
Status
Not open for further replies.

Reply to Grab Your New 17 Plate Van Now with Vansdirect! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
200
SimonG
SimonG
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
128
Lou
Lou
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
Lou
Lou
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
dreikher
dreikher
Dan
  • Sticky
Australia Morning Thread
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
77
Dan
Dan
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers Forum
Tile Forum
Tiling Advice
Tile Blog
UK Tiling Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock