Search the forum,

Glow worm 18hxi overheating high limit cuts in but display reads 35o

Post new thread

Discuss Glow worm 18hxi overheating high limit cuts in but display reads 35o in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

swindon

High limit cuts in with f5 but display reads 35oC
Replaced flow/return thermistors but still the same
flow temp gets to about 87oC
Differentials about 9oC on hot water
Any ideas?
 
This plumbing forum will not provide advice to anybody with regards to boiler repairs or any other form of gas plumbing without you first providing us with your Gas Safe Registration number in a thread - for very obvious reasons. If you're not qualified to touch gas, you should stay well clear of trying to!
 
Status
Not open for further replies.

Reply to Glow worm 18hxi overheating high limit cuts in but display reads 35o in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
344
Chuck
C
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
303
oz-plumber
O
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
232
DIwhYdidIstartThis
D
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers Forum
Tiling Tools
Plumbers' Talk
Electrical Blog
BS 5389 Tiling Standards
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock