Search the forum,

Discuss Geberit flush mechanism in the USA area at PlumbersForums.net

Messages
2
Can anyone please explain how you detach the grey flush mechanism from the flush buttons? Couldnt find anything on the usual sources. Dont want to force it and break it. It's an older model Geberit flush mechanism.
 

Attachments

  • 20211123_092704.jpg
    20211123_092704.jpg
    272.4 KB · Views: 21
  • 20211123_092625.jpg
    20211123_092625.jpg
    307.5 KB · Views: 19
  • 20211123_092611.jpg
    20211123_092611.jpg
    400.4 KB · Views: 21
3 versions of the same picture, 1 being upside down doesn't give much to go on.
If you're replacing, i would replace both parts.
From what i can see try rotating the grey part it looks like theres a tang on the white part
 

Reply to Geberit flush mechanism in the USA area at PlumbersForums.net

Similar plumbing topics

We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
288
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
161
Hi guys....we have an old Astracast sink top....I think its a composite sink....has a big single bowl. My wife thinks it looks scruffy....looks ok to me.....sound but the bowl has seen a lot of work. So she wants a new one...Astracast it seems are no more. The problem is its size.....looked...
Replies
2
Views
168
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
2
Views
114
S
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock