Search the forum,

Gas Safe retains contract

Post new thread

Discuss Gas Safe retains contract in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Gasmk1

Gasmk1

Esteemed
Gas Engineer
Messages
2,140
I see gas safe have retained the contract is this good or bad.
 

Reply to Gas Safe retains contract in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Lou
  • Article
Plumber Who Worked Illegally Gets Suspended Sentence
A Plumber Who Worked Illegally Gets A Suspended Sentence After Falsely Claiming To Be Gas Safe Registered. A Plumber in Herefordshire was prosecuted after Hereford Trading Standards Team found that he was falsely claiming to be on the Gas Safe Register when he was not, putting members of the...
Replies
0
Views
113
Lou
Lou
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
443
FozzieBear
F
A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
251
oz-plumber
O
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
498
Chuck
C
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
132
fowlerboi
F
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock