Search the forum,

Gas safe engineer required

Post new thread

Discuss Gas safe engineer required in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

treebor

Hi , i know its not the usual done thing but would anyone consider fitting me a used boiler , providing it was relatively new and and full working condition , i only ask because i can`t afford to buy a new one and pay an engineer , i`m in Doncaster ,South Yorkshire
 
Status
Not open for further replies.

Reply to Gas safe engineer required in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Lou
  • Article
Plumber Who Worked Illegally Gets Suspended Sentence
A Plumber Who Worked Illegally Gets A Suspended Sentence After Falsely Claiming To Be Gas Safe Registered. A Plumber in Herefordshire was prosecuted after Hereford Trading Standards Team found that he was falsely claiming to be on the Gas Safe Register when he was not, putting members of the...
Replies
0
Views
201
Lou
Lou
P
  • Question
Could the BAXI commercial boiler parts/flue melt ?
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator pipes during the strip out. Not the end of the world as damages happens. I am responsible builder and paying my bills and to repair the damages if...
Replies
1
Views
29
ShaunCorbs
ShaunCorbs
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
501
FozzieBear
F
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
166
Lou
Lou
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forums
UK Tiling News
Tile Cutters
Plumbers' Talk
DIY Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock