Discuss Flush valve washer!! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

01ST13795

Gas Engineer
Messages
54
Anyone any idea on the manufacturer of these flush valves? Appears to be no make or model on it. Any help would be greatly appreciated!!

Thanks

Sam
 

Attachments

  • IMAG0198.jpg
    IMAG0198.jpg
    91.4 KB · Views: 71
Will be easier to go & purchase a Fluidmaster flush valve & Change the entire part! Don't forget the close coupled kit!

Not the easiest diy job, maybe call a local plumber if your not confident!

Imoften go to old toilets with cheap foreign internal parts, not alot can be done without a make or model!?
 
You won't need a close coupled kit, looks like its a concealed cistern...
 
Can't get access to take panel off behind toilet because how its fitted need to take toilet out, that's why I really want the washer, needle in haystack I no trying to find but thought it was worth a try.
 
Will be easier to go & purchase a Fluidmaster flush valve & Change the entire part! Don't forget the close coupled kit!

Not the easiest diy job, maybe call a local plumber if your not confident!

Imoften go to old toilets with cheap foreign internal parts, not alot can be done without a make or model!?

This^
You can pick up a complete flush kit for about ÂŁ20. Easier than messing about trying to find matching parts :)
Yeah, maybe i should have read the thread first :lol:
 
Last edited by a moderator:
That is defiantly a Wirquin flush valve mark 1. As far as I know the bottom flush valve seal isn't available anymore.

You can either replace your whole valve, but you will need to reuse the existing blue cable (which is longer than the original supplied) or the new Mark 2 fits your cradle but will need to make sure the cable is long enough for you.
 
Agree as I have same fitted at home ..got spares from here....C&N plumbing ltd 120_122 chingford Mount Road Chingford London e4 9bs Tel.020 8524 8006 ..regards Turnpin:lol:
 
Status
Not open for further replies.

Reply to Flush valve washer!! in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my...
Replies
3
Views
598
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The...
Replies
6
Views
298
Hi Does anyone recognise the make/brand of the radiator valve. It leaks when closed and Iam hoping I can replace a seal etc?
Replies
4
Views
268
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't...
Replies
6
Views
385
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
272
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock