Search the forum,

Floor drainage

Post new thread

Discuss Floor drainage in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Neil T

Neil T

Esteemed
Plumber
Subscribed
Messages
205
Hi, does anyone know where I could get one of these drain 'cups' from? Not even sure of the proper name for it. Its in a McDonald's and 2nd time I've had to deal with one of these. First time I just improvised with a multi appliance sink trap but there isn't enough space here. Cheers
 

Attachments

  • IMG_4532.jpg
    IMG_4532.jpg
    61.7 KB · Views: 34
Status
Not open for further replies.

Reply to Floor drainage in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
159
Lou
Lou
T
Trying to source a dual-flush valve
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
Replies
2
Views
211
Thomas J Marshall
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
212
dreikher
dreikher
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
6
Views
215
127bit
127bit
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
155
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Cutters
TilersForums.co.uk | UK Tiling Forum - Est 2006
Tiling Forum UK
Tiling Tools
Tilers Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock