Search the forum,

Discuss Cost to replace ideal logic 24+ sump in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
10
Hi all,
I have been informed my boiler sump on my ideal logic 24+ has a crack. A common fault on the ideals by the looks of it. I can source the sump for about 55 quid. How much would you say is reasonable to replace the part.
Ps I've just had my boilers serviced and they never noticed the rust for weere it has been leaking which is a little disconcerting.
Regards Jim
 
any rust within a boiler case is potentially serious, you should have been told .
I changed a sump on one a month ago , admittedly a regular customer, I charged £60 plus cost of sump .
 
any rust within a boiler case is potentially serious, you should have been told .
I changed a sump on one a month ago , admittedly a regular customer, I charged £60 plus cost of sump .
Ha....not a think mate. I was told it was like new .. I've requested a job on mybuilder so we'll so what they come back with.
 
I wasn't here but my mum was and said her was her for a while concerned with there service. I haven't had the bill yet so might contest paying the full amount for them service.
 
Crack seems to be in the usual place

20190506_194254.jpg


20190506_194829.jpg
 
I know what your gonna. And yes I did. It was leaking water everywhere. It's all back on now.
The boiler was turned off and I have readers in the cupboard. I haven't messed with anything else.
 
You now need to get someone in to make sure that it is all ok. As you have taken the case off.
 
Status
Not open for further replies.

Reply to Cost to replace ideal logic 24+ sump in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
139
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
212
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
202
P
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
137
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
191
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock