Search the forum,

Can't figure out how to remove speed fit pipe fitting

Post new thread

Discuss Can't figure out how to remove speed fit pipe fitting in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

Phill2017

Messages
1
8C8C46D4-9CD2-4B05-8BE8-82A82A670945.jpg
Can any help with information on how to remove the pipes from this speed fit fitting? I don't want to attempt something before I know what I'm doing. Thanks
 
Two fingers on the thin ring on the outside of the fitting and then pull towards the fitting whilst pulling the pipe away in the opposite direction ..... turn the water off first lol
 
twist and pull
 
Can i ask what you are planning to do once you have disconnected it please kop.
 
Looks like the collar on left has been broken off. get a Plumber in!
 
Status
Not open for further replies.

Reply to Can't figure out how to remove speed fit pipe fitting in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
236
SimonG
SimonG
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
219
dreikher
dreikher
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
234
Timmy D
T
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
296
ShaunCorbs
ShaunCorbs
G
UK Moving Pipes Undersink for Dishwasher
Hello I am looking to install a slimline dishwasher (integrated) into a cupboard in my kitchen. The depth of the dishwasher is 550mm and the depth of my cupboard is larger than this. The issue, however, is that the waste pipe which leads from the sink (next door cupboard) comes out quite a...
Replies
22
Views
496
Basher
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forums
Electricians' Talk
Plumbing Advice
UK Tiling Forum
Electricians Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock