Search the forum,

C&m mx24 ff locking out

Post new thread

Discuss C&m mx24 ff locking out in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Andyh

Andyh

Gas Engineer
Messages
34
hiya fellas..
C& m mx24 ff locking out intermittently
Display flashing 70.. 80 lights
Swapped aps and that’s definitely proving at board
Can’t get through to anyone at ariston
Can anyone advise on gas valve readings or spark generator or could it be another pcb if anyone has any experience with this appliance any info much appreciated
 

Reply to C&m mx24 ff locking out in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
338
Timmy D
T
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
SimonG
SimonG
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Chuck
C
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
473
FozzieBear
F
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Talk
UK Tiling News
Tiling Blog
DIY Talk
Contractor Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock