Search the forum,

Discuss Akvaterm Solar Store in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
W

Wet Bandit

Hello gents,

I'm installing a 30 tube Thermomax system for a customer and would like to feed it into a 300 litre thermal store.

They have the intention of marrying up other fuel sources at a later date so the accumalator option's best. I like the look of the Akvaterm.

However, if their existing gas fired Potterton Suprima won't take preheated water, can you specify a boiler coil on it rather than take it through the store (black water)?

When they come to upgrading their boiler I'd install a fully modulating boiler and potentially an air source heat pump. The coil then becomes redundant but serves it's purpose to tie us over.

Any suggestions of stores that could do this or any other ideas?
 
Status
Not open for further replies.

Reply to Akvaterm Solar Store in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
191
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
229
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
226
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
436
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock