Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss A few points about testing electrics on boilers,the basics in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
B

Billy Bob Bob

May be useful to some,i once had a nasty bump off a 105 that was on a 3 pin plug,it was unplugged from the wall,the washing machine turned out to be faulty and was earthing through the plumbing and everything connected to it,the 105 got away with just showing a ntc fault,since that incident i have used a volt stick on the case before doing anything tests.jpg
 
lay the back of your hand on the case to see if its live, you wont grab on then :)
 
Status
Not open for further replies.

Reply to A few points about testing electrics on boilers,the basics in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
319
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
439
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
310
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock