Search the forum,
Questions and plumbing advice in the Water Underfloor Heating Advice - .

Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's

Forum Prefix Filter

Water UFH Installers Directory

Water Underfloor Heating Installers Directory. Here we help you find professional expert water underfloor heating installers in our free to use directory. Always use this forum as part of your own research. We can surely find you a water UFH installer with lots of references to check etc. :)
Threads
2
Messages
13
Views
6.7K
Threads
2
Messages
13
Views
6.7K
Hello I'm looking at the different pipes for UFH, the prices vary a lot and I'm not sure about the differences between the products. I'm doing two zones, one 127m the other 70m, both will be under screed. JG barrier pipe will cost £400 but Pert-Evoh-Pert is only £170. Both say they are 15mm...
Replies
3
Views
391
Hi, I have a seaside apartment in Azerbaijan, currently a bare core & shell, not even internal walls yet, and am intending to put in wet UFH with ceramic tiles on top. Although we will get someone to do this for us, in my experience here it's always best to have a pretty good idea of what needs...
Replies
4
Views
387
I have a Neura heat pump and my thermostat has failed (Theben RAM 797 b). I'm looking to replace it with another more modern one I can use with an app etc. My question is, can I replace it with any thermostat or do I require a very specific type thermostat to run the heat pump? Thanks for...
Replies
1
Views
363
Hi, I have a 3 storey house built in 1904. We put UFH in the house about 20 years ago. Works well with newish gas boiler. Just curious... I know heat pumps are meant for tightly insulated modern house ... but.. Question: Given that my UFH is always at a low temperature - Could I feed UFH with...
Replies
0
Views
357
Hi all. I've currently got a system boiler with cylinder and rads on s-plan. I'm planning on installing UFH in my kitchen/diner and utility/downstairs loo. My question is around mixing valves and opentherm. Do mixing valves dynamically adjust the amount of cold being mixed in response to the...
Replies
3
Views
353
We have a Daikin Air Source heat pump feeding our hot water and under-floor 8 port manifold heating system. The Daikin has just had its annual service and the engineer commented that the water looked discoloured and that the inhibitor needed replacing?? Is this an easy procedure? I'm pretty...
Replies
0
Views
338
I have some strange noises coming from the system, the majority are caused by the flow meters, the clicking noise. But there are other noises, ive managed to capture these on a video, keen to see what everyone thinks..
Replies
2
Views
275
We have a three zone heating system plus water cylinder (OSO Super S 250L) on an Valliant EcoTec 637. Two CH zones and a UFH zone. Boiler is rarely at maximum power rating, even at full tilt. The UFH zone has it's own pump and the other two zones (three storey house) are just pumped from the...
Replies
3
Views
237
Similar to radiator dT's, is there a way to mathematically calculate the UFH pipe centres required to satisfy a given room's heat demands? 150mm-250mm centres are banded about online, with no real explanation, obviously smaller centres allow for lower water temps, but there must be a more...
Replies
1
Views
143
Post a New Thread / Question
Creating content since 2001. Untold Media.
OFFICIAL SPONSORS

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock