Search the forum,

Where Is The Cold Water In Filter On Turbomax Plus?

Post new thread

Discuss Where Is The Cold Water In Filter On Turbomax Plus? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

plumbandplumber

Messages
272
I've recently done some plumbing work on my house, and I think some debris may have got into the boiler as hot water flow is slower. Cold taps are fine. Research leads me to the filter on the incoming cold side of boiler, but I can't see anywhere that tells me where it is.

Can anyone give me a pointer where this filter is please? Many thanks.
 
Status
Not open for further replies.

Reply to Where Is The Cold Water In Filter On Turbomax Plus? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Drain down/flush options for combi return that goes up not down.
Hi All This is following on from thread I made a few days ago but can't seem to find I'm in a bit of a bind with my CH design where I want to sort all of my rads and do some other bits including fitting a filter but I'm stumped on how to drain down due to how the system is put together...
Replies
0
Views
409
pipeit
P
B
Vaillant TURBOMax Plus 828E - Partial Load Setting d.00 problems
Hi, I have a TURBOMax Plus 828E in a small Annex that only has 3 Rads. The boiler Cycles but is only ignited for about 30-40 seconds before reaching target Temp and then goes on pump overrun. Given that there are only 3 Rads and are 'designer' with a total combined KW spec of about 2.5kw, the...
Replies
0
Views
699
bwel
B
T
rads cold no indication of boiler fault HW fine (pls urgent)
Hi All Bit of an urgent one being that time of year and can't get a plumber out until after xmas even on an emergency callout I have just tried to turn on my CH for the first time this year as I have a number of guests coming for xmas dinner but even after an hour all the rads are stone...
Replies
2
Views
290
John.g
J
S
Where is the hidden central heating pipe leak causing low pressure?
I have been facing central heating low pressure on unvented hot water RM Cylinders but can't see any leak on the PRV, expansion vessels and plasterboard celling. I have got unvented pressurized RM Cylinders hot water system with 27KW Worchester gas boiler with expansion vessels . When...
Replies
2
Views
461
losing pressure
L
N
New rads added - last one cold
Hi - I'm a reasonably experienced DIY plumber but just can't work out why the last new rad I've installed is cold - would really appreciate your help please. I've extended an existing 'run' of radiators - the last one on the run ( in downstairs kitchen) is cold. The first rad added is...
Replies
7
Views
627
Zippymark
Z
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock