Discuss What to do when there's too much water damage? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
7
First things first, I've been watching Shannon for years but this is my first post.

I'm facing an issue and need your help.
 
First things first, I've been watching Shannon for years but this is my first post.

So long story short, I've gotten in over my head with what started as a new toilet and supply line turned into gutting the whole bathroom. It's a half bath addition, absolutely nothing is code and there is so much water damage. I've pull the sheet vinyl and found rotted hard wood floors so I pulled those and found a huge hole and not as rotten wood slats, but still very wet.

The drywall is wet and moldy, gnats and smells galore, and I've been running 2 dehumidifiers around the clock in this tiny, tiny bathroom with minimal results.

How do I fix this? I was told to just dry it out and go over with plywood for a new floor but is it going to dry?

These people are on a very tight budget and I'm just doing this to help them out and to gain experience. But I want it to be right and look good, I don't do half bum jobs so somebody help a girl out with some real life experience with not your average bathroom.
 
First things first, I've been watching Shannon for years but this is my first post.

So long story short, I've gotten in over my head with what started as a new toilet and supply line turned into gutting the whole bathroom. It's a half bath addition, absolutely nothing is code and there is so much water damage. I've pull the sheet vinyl and found rotted hard wood floors so I pulled those and found a huge hole and not as rotten wood slats, but still very wet.

The drywall is wet and moldy, gnats and smells galore, and I've been running 2 dehumidifiers around the clock in this tiny, tiny bathroom with minimal results.

How do I fix this? I was told to just dry it out and go over with plywood for a new floor but is it going to dry?

These people are on a very tight budget and I'm just doing this to help them out and to gain experience. But I want it to be right and look good, I don't do half bum jobs so somebody help a girl out with some real life experience with not your average bathroom.
Thanks in advance for any suggestion and assistance!
 
If it’s wet rip it out and replace
 

Reply to What to do when there's too much water damage? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
232
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
247
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
265
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Replies
8
Views
408
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
334
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock