Hi
I have installed a UFH system - 2 zones - one area has a screeded floor with standard pipe system in screed, the other is aluminium spreader plates with floor boards over. Wundatrade system.
The whole area has engineered oak flooring over the top. Each zone controlled by hard wired stat and a floor probe set to 27 c.
The problem seems to be that the floor probe quickly reaches temperature and shuts the system down, thus making it hard to reach the required room temperature.
Wundatrade are going to talk me through checking the floor probe temperatures tomorrow, and assuming they're functioning ok I'll ask their advice.
Just wondering if anybody on here has any advice or has experienced this problem. Temp on manifold flow is around 50 c. All worked fine before the flooring went down and we switched to "all sensors".
I have installed a UFH system - 2 zones - one area has a screeded floor with standard pipe system in screed, the other is aluminium spreader plates with floor boards over. Wundatrade system.
The whole area has engineered oak flooring over the top. Each zone controlled by hard wired stat and a floor probe set to 27 c.
The problem seems to be that the floor probe quickly reaches temperature and shuts the system down, thus making it hard to reach the required room temperature.
Wundatrade are going to talk me through checking the floor probe temperatures tomorrow, and assuming they're functioning ok I'll ask their advice.
Just wondering if anybody on here has any advice or has experienced this problem. Temp on manifold flow is around 50 c. All worked fine before the flooring went down and we switched to "all sensors".