Search the forum,

Discuss Sizing Heat Sink radiator for wet hetas install in the Oil and Solid Fuel Forum area at PlumbersForums.net

G

G-laaar

Hi - I've had some conflicting advice so looking for confirmation please - what size should a heat sink radiator for a log burner/boiler be? I've been told by one installer 10% of output to water and another 20%. I can;t find aything in building regs and can;t find a HETAS document with that info included so a poitn in the right direction so I can challenge with confidence would be great please.
 

Reply to Sizing Heat Sink radiator for wet hetas install in the Oil and Solid Fuel Forum area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
451
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock